Metal roofing is the long game. A properly installed standing seam metal roof will outlast two or three asphalt shingle roofs, shrug off hurricane winds that would strip other materials, and cut your cooling costs noticeably thanks to its reflective surface. It is a bigger upfront investment — and it is also the last roof most homeowners will ever buy.
Celestia Crest installs premium standing seam and screw-down metal roofing across South Florida. Our crews are trained on custom flashing, concealed fastener systems, and the hurricane-zone details that make the difference between a great metal roof and a leaky one. If you are ready to make a 40-to-70 year commitment to your roof, we are the team to install it.
Metal roofing rewards attention to detail like no other system. A single improperly-driven fastener can back out years later and create a leak. A poorly fabricated valley can channel water under a panel. Our metal crews fabricate flashings on-site, use manufacturer-specified clip spacing, and finish every panel with the precision the system demands. The result is a roof that looks as sharp in year 40 as it did in year 1.
Metal roofing is also one of the best options for homes with solar panels. The standing seam profile allows for clamp-on solar mounting with no roof penetrations at all, preserving both the warranty and the watertight integrity of the roof. If you are considering solar now or in the future, a metal roof is the single best surface to put it on — and the longest-lasting by a wide margin.
We also handle all of the custom metalwork in-house — valleys, ridge caps, rake trim, drip edge, and specialty flashings. Panels and trim fabricated to the exact measurements of your roof mean cleaner lines, tighter seals, and better long-term performance. You can see the difference in the first look at a finished roof, and you can feel it every time it rains hard.
Standing seam metal is the highest wind-rated residential roofing available — rated to 150+ mph when installed correctly.
Reflective metal finishes reduce roof surface temperature and cooling loads — cutting summer energy bills noticeably.
Properly installed metal roofs routinely outlast asphalt roofs 2-3 times over, with minimal maintenance.
Metal roofs are fully recyclable at end of life and often contain recycled content from the start.
Concealed-fastener standing seam panels — the premium metal roofing choice for homes and commercial buildings.
5V Crimp and R-panel exposed-fastener systems — a lower-cost metal roofing option for outbuildings and utility structures.
Full replacement of aging metal roofs, including proper deck inspection and underlayment replacement.
Panel replacement, flashing repair, fastener re-sealing, and leak diagnosis for existing metal roofs.
Chimney, dormer, valley, and custom architectural flashing fabricated to fit your specific roof.
Standing seam and structural metal systems for warehouses, churches, restaurants, and class-A office buildings.
Choose panel profile, gauge, and finish — we bring samples of standing seam, 5V crimp, and designer options.
Most metal roofs require full tear-off. We inspect the deck and replace any damaged wood.
High-temp synthetic underlayment and custom-fabricated flashings installed before the panels go on.
Panels cut to exact length, installed with concealed clips, seamed, and trim-finished for a clean, weathertight result.
No — not on a properly installed system. Metal roofs over solid decking and underlayment are no louder than asphalt roofs inside the home.
Yes. Metal roofs often add 1-6% to resale value thanks to their long lifespan and energy efficiency.
Typically 2-3x the cost of asphalt shingles upfront, but lasts 2-3x as long — often a better value over the life of the roof.
Quality Kynar 500 finishes are designed to resist fading for 30+ years. Lower-grade paint systems fade faster, which is why we recommend Kynar-coated panels.
No. Metal roofs do not block cell signals any more than regular roofing materials do, because modern panels do not create a faraday cage effect.